Robotics
Board requirements across robotics vary widely, and selection is usually driven by some combination of heat dissipation, signal integrity, structural space and reliability grade. Below are the engineering considerations that come up most often in this area, together with the 4 applicable board types we already manufacture.
Engineering considerations
- Repeated bend life
- Moving joint sections suit flex or rigid-flex construction, with bend radius and routing direction fixed at design stage. State the required bend cycles when enquiring so engineering can assess it.
- Drive and signal coexistence
- Servo drive coexists with sensor and communication signals on the same assembly, calling for impedance consistency and interference separation. Standard impedance tolerance is ±10%; tighter targets require engineering review.
Applicable board types
The board types below are the ones that come up most often in robotics applications. Each link goes to that board type's capability page with material, layer-count and process ranges. Combined constructions across board types, such as hybrid lamination or embedded copper, are confirmed by engineering review.
Production experience
Related end-product categories already in volume production include Documented end-product categories in robotics include industrial robots and drones.. Specific project details are covered by non-disclosure agreements and are not published.
Applicable certifications
- ISO 9001:2015 Quality Management System — 120622-2012-AQ-RGC-RvA
- ISO 14001:2015 Environmental Management System — 104573-2011-AE-RGC-RvA
- RoHS Restricted Substances Test Report — WTH23H12270526C
- REACH SVHC Test Report — WTH24H10245077C
Frequently asked questions
- How long does a robotics project take from enquiry to prototype?
- Quotations are returned within 30 minutes as a rule. Expedited prototype lead times run by layer count: double-sided 24 hours, 4-layer 48 hours, 6–8 layer 72 hours, 10–12 layer 96 hours; single-stage HDI at 6 layers is 48 hours. Standard lead times and production scheduling are confirmed separately against order volume.
- Which inspection and material documents can you supply?
- As standard we supply a certificate of conformance, material certifications with lot records, and electrical test records; impedance test reports and microsection analysis are available on request. Acceptance can be run to IPC-6012 Class II or Class III, which must be stated on the order.
This page describes general engineering considerations for this application area and the board-type capabilities we already hold. It is not a commitment on a specific project. Exact stack-up, material grade, tolerances and acceptance criteria are confirmed through engineering review and in writing.
Routine enquiries are answered within 30 minutes. Once you upload Gerber files and technical requirements, engineering returns manufacturability findings together with the quotation, so design conflicts surface before production rather than after.