LED Lighting
Board requirements across led lighting vary widely, and selection is usually driven by some combination of heat dissipation, signal integrity, structural space and reliability grade. Below are the engineering considerations that come up most often in this area, together with the 4 applicable board types we already manufacture.
Engineering considerations
- Heat dissipation and junction temperature
- LED lumen depreciation tracks junction temperature, so the thermal path drives selection. Aluminum-base and metal-core boards offer different thermal conductivity options, with aluminum-base running to 1500 mm on the long edge for strips and panel lights.
- High volume and long-strip formats
- Lighting products are typically high-volume single-sided builds where cost and panel efficiency dominate. Long-strip and irregular outlines have their routing method confirmed at quotation stage.
Applicable board types
The board types below are the ones that come up most often in led lighting applications. Each link goes to that board type's capability page with material, layer-count and process ranges. Combined constructions across board types, such as hybrid lamination or embedded copper, are confirmed by engineering review.
Applicable certifications
- ISO 9001:2015 Quality Management System — 120622-2012-AQ-RGC-RvA
- ISO 14001:2015 Environmental Management System — 104573-2011-AE-RGC-RvA
- RoHS Restricted Substances Test Report — WTH23H12270526C
- REACH SVHC Test Report — WTH24H10245077C
- UL Recognized Component (USA) — Wiring, Printed — E326765 (ZPMV2)
- UL Recognized Component (Canada) — Wiring, Printed — E326765 (ZPMV8)
Frequently asked questions
- How long does a led lighting project take from enquiry to prototype?
- Quotations are returned within 30 minutes as a rule. Expedited prototype lead times run by layer count: double-sided 24 hours, 4-layer 48 hours, 6–8 layer 72 hours, 10–12 layer 96 hours; single-stage HDI at 6 layers is 48 hours. Standard lead times and production scheduling are confirmed separately against order volume.
- Which inspection and material documents can you supply?
- As standard we supply a certificate of conformance, material certifications with lot records, and electrical test records; impedance test reports and microsection analysis are available on request. Acceptance can be run to IPC-6012 Class II or Class III, which must be stated on the order.
This page describes general engineering considerations for this application area and the board-type capabilities we already hold. It is not a commitment on a specific project. Exact stack-up, material grade, tolerances and acceptance criteria are confirmed through engineering review and in writing.
Routine enquiries are answered within 30 minutes. Once you upload Gerber files and technical requirements, engineering returns manufacturability findings together with the quotation, so design conflicts surface before production rather than after.